Replaced glow plugs and ignition switch. Battery new. Ignition light does not come on. Prior the it would sporadically start. Does anyone have a wiring schematic? Cou...
Replaced glow plugs and ignition switch. Battery new. Ignition light does not come on. Prior the it would sporadically start. Does anyone have a wiring schematic? Cou...
Dennis, I don't beleive the check engine light has any way to be turned on from anything in the hydraulic system. I think you have another issue going on.
I'd start with inspecting the linkage. This might be helpful. I have seen some issues with the pedal damper (#33)
I'm pretty sure the side cover needs to come off to acess the snap ring that's on the back side of the axleby the gear. Then the axle will pull out and alow you to replace the seal.
@Lonnie On that I'd lean towards something electrical, like a chafed wire or something. If it was a bad sender I'd expect it to be a constant.
Trying to understand adding dual rear remotes with these parts number kits?008032505K51 and 008032506K51 What exactly is in the kits, first one is for a single, second is the dual do you need to bu...
Thanks I might try it, another thing it does is that sometimes the high temp gauge goes full and flashes even though nothings really overheating. Does that sound related at all to the electri...
Any advise on removing the Loader subframe? Just purchased a used tractor. On closer inspection I found all the subframe bolts to be loose and two of them sheared off. How would you handle the remo...
If it were me, I’d start by looking at fuel delivery because what you’re describing really sounds like it’s starving for fuel under load. The fact that it runs fine after sitting ...
if the seal felt loose going in that’s usually a worn seal bore in the housing. maybe Loctite 620/640 retaining compound would work and lightly staking the bore so the new seal has some bite....
I agree with Topher. You don't give any other details other than it used to start with no problems, in the cold. (I.E., whether you have a block heater used, stored inside or not, whether you use a...
Does anyone else have leaking and loose rear outer axle seals. I have put new seals in from Mahindra on one axle side and it pushed the whole seal out while mowing- I thought the seal felt loose pu...
I removed and replaced the breather and I even drilled the air escape hole alittle bigger so I was sure pressure buildup was not happenening
If it is a 2023, I am thinking it is still under warranty. Certainly sounds like air in the hydraulics.
Take oil fill cap off and see if there is extra pressure / pulsing when tractor is running. If it is, find the PCV valve and make sure it clear of any ice / debris build up.
I have a 3616 HST Cab with a front load snowblower and rear sand/salt spreader. Tractor starts fine, engine rpms or ok, PTO work fine but the forward and reverse foot control is not functioning, Tr...
Any detail description on replacing seals would be appreciated. Thanks.
While mowing and snow blowing occasionally my engine would die down and sometimes stall. I shut it off and let it set. Started it back up and it ran fine. Chanced all the filters, added fresh fuel ...
Did both and it is smoking blue like crazy. Filled the cab with smoke
