All Posts

  • @Zane  did you resolve your issue?  Mine is doig the same exact thing. 

    Eric posted in mPower 85P •
  • I was cutting up a field and then traveled to the next one and it just died. After letting it sit a while it cranked and runs about a minute or so and then died again. No smoke and plenty of fuel a...

    Eric posted in 5555 •
  • New battery. I turn the key and the starter will not engage. It makes the clicking noise like a dead battery. I am not sure where to go from here.  

    Donnie posted in 2538 •
  • Hi everyone. I wanted to ask if anyone that has a 1626 ever able to increase the hydraulic pressure on the loader. I can't find any kind of info on the relief valve location. Says on the joystick. ...

    Steven posted in 1626 •
  • I have a 2538 and the arms for lifting the 3 point hitch will not lift. Fluid looks good level is correct and electrical switch is replaced. 

    Tanya posted in 2538 •
  • Hello.  When I turn the key there is nothing happening.  No lights on dash nothing... where are the fuses located..  

    Michelle posted in 1626 •
  • Anyone know how to fix and odometer that is not working. Sometimes it seems to work for a few seconds then moved to the max or drops back close to 0.

    Joseph posted in 9110P •
  • Anyone know how to remove the accelaerator (orange) and pc (black) rubber knobs on the RH side of an 1123 tractor ?

    Richard posted in 1123 •
  • My 5010 does everything it's supposed to except start and run. I checked the safety switch at the clutch pedal and it's good. I changed the relays under the hood, still nothing. New battery, still ...

    Chris posted in 5010 •
  • Has anyone changed out a broken PTO shaft on a 6110 ?

    Terry posted in 6110 •
  • My MP 85P has started sounding an alarm after five minutes of running. Ive check fluid leves and for water in the fuel filter and all is good. Any idea what else could be causing this alarm to go o...

    mark posted in mPower 85P •
  • Added front grappler to my tractor. Worked fine for season, then could not get jaws to open or close, or close once open. Disconnected front hydraulic lines to make sure fluid flows and looks fine....

    Eugene posted in 3616 •
  • Have had tractor since Aug of 2025, and have had no issues. Have 64 hrs and tractor had done everything I have wanted.

    Richard A posted in 1640 •
  • Why is my parking brake light blinking? Stops and fully lights when it is locked. Thanks Bob

    Robert posted in 1120 •
  • Does anyone have a manual for the Bishop BSMM1572 mower deck or know where I can get one?

    Gene posted in 3015 •
  • My 5010 has had starting issues.  It will work fine for a while and then one morning when I turn the key I just get a buzzing (fast clicking) sound and irratic dash lights.  It continues ...

    Bob posted in 5010 •
  • The block Heater for the 1526 Is crazy expensive. I'd sugest trying some additive in the fuel in the colder times. It's super simple, dump a bottle directly into the fuel tank when it's at 3/4-full...

    Nick posted in 1526 •
  • This past winter while plowing I picked up a rock and it bent the fan blade on my 48" snow blower. Are there instructions available to remove and replace the fan blade. The part number for the blad...

    Michael posted in eMax 20S •
  • Hi, has anyone purchased the block heater? How does it do in cold weather? Believe it or not, I live in Arizona and this time of year gets down to 30°F and until it gets above 65°F, it will...

    Gerald posted in 1526 •
  • Does anyone know where I can purchase a brush guard insert for a Mahindra Max 26XLT ? I've searched the internet to no avail. Seems like all the inserts are for Kubota and other brands, but none fo...

    Bo posted in Max 26 XLT •